Increase the ROI on your starter fertilizer investment with the 360 DASH application system. 360 DASH lets you apply the maximum rate for yield response while trimming your starter volume per acre - and cost per acre - by 50% to 75%. Rather than a continuous stream of liquid fertilizer, the 360 DASH valve meters a two- or three-inch "dash" of fertilizer and positions it for rapid interception by seedling roots.

The "dash" is triggered by a passing seed. When the existing seed sensor detects a seed, 360 DASH fires a high-speed actuator. The 360 DASH needle valve controls the rate and pulses. Achieve accurate pulses of fertilizer at four to 10 mph and 2.5 to 15 GPA.

The 360 DASH system adapts to existing power and data communication architecture on Precision Planting and John Deere ExactEmerge high speed planters. An innovative, wireless WIFI communication system from each valve reduces harness cost and reliability issues.

360 DASH includes a flow meter and filter. This meter is accurate over a wide flow range (.025 - .65 GPM) and is compatible with common liquid products (water, 28%, 10-34-0, biologicals and more). Each flow meter communicates rate to the 360 DASH valve, then through the wireless communications hub, back to the 360 DASH control app in the cab.

KEY FEATURES

360 DASH applies liquid fertilizer in a concentrated dash over the seed. Eliminating the less efficient starter between seeds - gaining the full benefit of the starter but with a fraction of the cost.

The 360 DASH valve can be used with a variety of starter application tools including the 360 WAVE and most Keeton Seed Firmers.

360 uses an AgXcel pump system with the "360 DASH Package" (sold separately) to ensure compatibility with the 360 DASH control app and to ensure uniform pressures and filtering.

Set up and control settings are simplified via the 360 DASH App on your iPad. You set the length of the "dash" and its position - on, between or next to the seed.

• Pressure Transducers on both the inlet and outlet of the pump

• A Master Ball Valve to hold pressure

• 50PSI Pressure Regulator to ensure you never build too much pressure

• Two Positive Displacement Diaphragm Pumps to ensure consistent application at the rows

• Turbine Flow Meter to accurately dispense and adjust rate as needed

• Two filters to prevent plugging the pumps

• AgXcel's Custom PWM to lock in on all desired rates